Bronco L6-300 4.9L VIN Y 1-bbl (1983)
CORRECTION OF SURFACE FOLLOWING DECONTAMINATION:
1.
Visually inspect surface for evidence of removal of ferrous metal particles, crystalline deposits and water spots. Acid rain discoloring or etching
will require either buffing, color sanding or refinishing if etching is visible.
2.
Use the buffing products from only one (1) manufacturer. Do not intermix products.
3.
Always follow the manufacturer's product sequence. Use appropriate pads with each product as recommended by the manufacturer.
NOTE:
DO NOT REMOVE MORE THAN 0.3 OF A MIL OF PAINT MATERIAL, OR REPAINTING WILL BE REQUIRED.
4.
Use a dual action sander (D/A Sander) with a velcro-mount backing plate and appropriate foam pad for final polishing swirl removal.
5.
Use an alcohol and water mixture (1:4 ratio) to clean buffed areas to verify removal of scratches and swirls before application of final protective
glaze.
NOTE:
FREQUENT WASHING OF VEHICLES IS IMPORTANT. CONTAMINANTS SETTLE ONTO THE VEHICLE EVERY DAY. USE CLEAN
WATER (DEIONIZED, REVERSE OSMOSIS, ETC.) TWICE WEEKLY TO REMOVE HEAVY DUST, AND PARTICULATES. THE USE OF
A NEUTRAL pH CAR WASH SOAP EVERY TWO (2) WEEKS IS RECOMMENDED TO NEUTRALIZE VEHICLE CONTAMINATION.
Parts Block
NOTE:
DEALERS SHOULD USE PROGRAM CODE R-23 AND CONDITION CODES C5 AND C6. REFER TO W & P MANUAL, SECTION 5-1,
PAGE 3.
OTHER APPLICABLE ARTICLES: 91-18-1, 92-6-4
WARRANTY STATUS: Eligible Under The Provisions Of 12 Month/12,000 Mile Basic Warranty Coverage
OPERATION
DESCRIPTION
TIME
950601A
Decontaminate And Surface
0.6 Hr.
Correction - Aspire
950601B
Decontaminate And Surface
0.6 Hr.
Correction - Escort/Tracer
950601C
Decontaminate And Surface
0.6 Hr.
Correction - Probe
