Bronco L6-300 4.9L VIN Y 1-bbl (1983)
(1) Actuator Assembly, Steering Column Lock
10. Install the key release lever assembly on 4-speed equipped vehicles and the PRND21 insert on vehicles with automatic transmission. Install the
T-bolts and lock actuator insert.
NOTE: Retain the ignition switch actuating rod from the removed casting assembly and use it with the new flange casting assembly.
Installation
1. Reassemble the above parts, install a new upper shaft bearing and set the actuator to drive gear.
2. Install the turn signal-hazard warning switch and key warning buzzer.
3. Install the ignition switch, check and/or adjust for proper function.
4. Install the steering column assembly to the brake pedal support bracket.
5. Install the steering column trim shrouds, steering wheel and pad assembly.
6. Install the turn signal lever.
7. Using the ignition key, rotate the lock cylinder to insure correct mechanical operation in all positions.
8. Connect the battery ground cable.
9. Check for proper start in Park and Neutral. Also check to make certain that the start circuit cannot be actuated in the Drive and Reverse
positions.
