ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Steering Gear to Fluid Cooler Return Hose > < Steering Gear Bushing

C-MAX 2003.75 (06.2003-)

Power Steering - Power Steering Pump—Vehicles With: Electro-Hydraulic Power Steering (EHPS) C-MAX 2003.75 (06/2003-)
Removal and Installation

Special Tool(s)

Remover/Installer, Hose Clamp

303-397
General Equipment
Worldwide Diagnostic System (WDS)

Removal

  1. Obtain and record the power steering system program code using WDS.
  1. Remove the right-hand headlamp assembly.
    For additional information, refer to: Headlamp Assembly (417-01 Exterior Lighting, Removal and Installation).

  1. Disconnect the power steering pump electrical connectors.
  1. Remove the right-hand front wheel and tire.
    For additional information, refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

  1. Remove the engine undershield.
    • Rotate the locking tangs counterclockwise.

  1. Remove the radiator splash shield.

  1. Remove the right-hand front fender splash shield.

  1. CAUTION:
    CAUTION:Cap the power steering pump outlet union to prevent fluid loss or dirt ingress.
    Disconnect the power steering pressure line from the power steering pump.
    • Allow the fluid to drain into a suitable container.

  1. CAUTION:
    CAUTION:Cap the power steering fluid return line to prevent fluid loss or dirt ingress.
    Disconnect the power steering fluid return line from the power steering pump.
    • Allow the fluid to drain into a suitable container.

  1. Remove the power steering pump.

Installation

  1. To install, reverse the removal procedure.
  1. Fill and bleed the power steering system. For additional information, refer to: (211-00 Steering System - General Information)
    Power Steering System Filling - Vehicles With: Electro-Hydraulic Power Steering (EHPS) (General Procedures),
    Power Steering System Bleeding - Vehicles With: Electro-Hydraulic Power Steering (EHPS) (General Procedures).
  1. WARNING:
    WARNING:The power steering system must be re-configured. Failure to follow this instruction may result in personal injury.
    Configure the EHPS control module.
    For additional information, refer to: Module Configuration (418-01 Module Configuration, General Procedures).

Steering Gear to Fluid Cooler Return Hose > < Steering Gear Bushing