Removal and Installation Worldwide Diagnostic System (WDS) | -
Disconnect the battery ground cable. For additional information, refer to: Battery Disconnect (414-01 Battery, Mounting and Cables, General Procedures). | | -
Remove the right-hand rear seat. | | -
Raise the center rear seat base. | | -
Remove the right-hand rear scuff plate trim panel. For additional information, refer to: Rear Scuff Plate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation). | 5. Remove the components in the order indicated in the following illustration(s) and table(s). 6. To install, reverse the removal procedure. | -
Vehicles with global closing, initialize the door window motors. For additional information, refer to: Door Window Motor Initialization (501-11 Glass, Frames and Mechanisms, General Procedures). | | -
Refill the fuel additive tank. For additional information, refer to: Fuel Additive System Filling and Bleeding (310-00 Fuel System - General Information, General Procedures). | | -
Configure the fuel additive system module. For additional information refer to WDS. - Navigate to Toolbox Option Module Programming then Toolbox Option Powertrain navigate from there to the FACM Service Function within the section select item New FACM.
| Removal Details Item 1 : Rear floor covering | -
Detach the rear floor covering to expose the fuel additive system module. | Item 3 : Fuel additive system module electrical connector | -
Disconnect the fuel additive system module electrical connector. - Release the locking tang.
| |