ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Blower Motor Resistor - Vehicles Built From: 10-2005, Vehicles With: Dual Automatic Temperature Control > < Footwell Vent-Duct Blend Door Actuator - RHD

C-MAX 2003.75 (06.2003-)

Control Components - Blower Motor Resistor—RHD C-MAX 2003.75 (06/2003-)
Removal and Installation

WARNING:
WARNING:Never perform operations on the blower motor resistor before the blower motor resistor has cooled to ambient temperature. Failure to observe this instruction can lead to injury.
  1. Remove the center console extension. For additional information, refer to Section  501-12 Instrument Panel and Console.

2. Remove the components in the order indicated in the following illustration(s) and table(s).

 
Item
Part Number
Description
1
-
Footwell trim panel screws
2
-
Footwell trim panel
3
-
Glove compartment side trim
4
-
Glove compartment screws
5
-
Glove compartment light switch connector
6
-
Glove compartment light connector
7
-
Glove compartment
See Removal Detail

 
Item
Part Number
Description
8
-
Blower motor resistor connector
9
-
Blower motor resistor retaining bolts
10
-
Blower motor resistor

3. To install, reverse the removal procedure.

Removal Details

Item 7 : Glove compartment
  1. Disconnect passenger airbag (PAD) deactivation switch connector (if fitted).

Blower Motor Resistor - Vehicles Built From: 10-2005, Vehicles With: Dual Automatic Temperature Control > < Footwell Vent-Duct Blend Door Actuator - RHD