ford Workshop Repair Guides

Ford C-MAX Workshop Service and Auto Repair Manuals

General Procedures|Removal and Installation > < Azimuth System Check
Parking Aid - Vehicles With: Front Parking Aid - Elevation System Check C-MAX 2003.75 (06/2003-)
General Procedures

Front Parking Aid

  1. NOTE:
    NOTE:To activate the front parking aid system the ignition must be turned to position II.
    NOTE:
    NOTE:Do not apply the parking brake as this will deactivate the front parking aid system.
    NOTE:
    NOTE:If a parking aid switch is fitted the system will be de-activated and a light emitting diode (LED) will indicate the state of the system. A lit LED will indicate that the system is currently deactivated.
    NOTE:
    NOTE:If the parking aid system is faulty, an error tone approximately 3 seconds long will be issued at each ignition cycle or the first activation of the system. If an LED is fitted and is lit, this will indicate that a fault is present in the system.
    Activate the front parking aid system.

  1. NOTE:
    NOTE:The front parking aid system measures the distance to the closest obstacle when manoeuvring and helps the driver to judge distances correctly by audible signals.
    Ground reflection verification and sensor coverage pattern.
  1. CAUTION:
    CAUTION:Do not clean the sensors with abrasive or sharp objects. Failure to follow this instruction may result in premature failure of the parking aid sensors.
    Make sure the front parking aid sensors are free from ice, snow, dirt, scratches or grime.
  1. The parking aid system must be checked to make sure that the system does not see signals from ground reflections.

  1. NOTE:
    NOTE:When checking the front parking aid system make sure that there are no obstacle(s) to the front, rear or side of the vehicle within the range shown. Failure to follow this instruction may give a false reading of the front parking aid sensors.
    Check the vehicle is clear from obstacles to the front, rear and sides.
  1. NOTE:
    NOTE:Make sure the vehicle is not overloaded and is on a flat surface. Failure to follow this instruction may give a false reading of the rear parking aid sensors.
    The following system check should be carried out with the vehicle on an approximately 4.8 meters wide by 3.00 meters deep surface, free of all obstacle(s). The area should also be free of noise, especially from fans and pneumatic tools.
  1. NOTE:
    NOTE:Do not apply the parking brake as this will deactivate the front parking aid system.
    NOTE:
    NOTE:The front parking aid sensors only operate below 10 Km/h.
    With the aid of another technician apply the brakes and select drive or first gear.

  1. NOTE:
    NOTE:If any audible alerts are heard, check to make sure the bumper is properly installed and is not tilted downward so the sensor is pointing toward the ground.
    NOTE:
    NOTE:If any audible alerts are heard, check to make sure the license plate has been correctly fitted.
    Verify that no audible alert is heard.

General Procedures|Removal and Installation > < Azimuth System Check