Removal and Installation 2. Remove the components in the order indicated in the following illustration(s) and table(s). 2 - Safety belt upper anchor retaining bolt 3. To install, reverse the removal procedure. Removal Details Item 1 : Rear center safety belt trim panel | -
Remove the rear center safety belt trim panel. - Open the screw covers.
- Remove the screws.
- Release the clips.
| Item 4 : Headliner | -
Detach the headliner from the roof panel to access the lower anchor retaining bolt. | Item 5 : Safety belt lower anchor retaining bolt NOTE:The safety belt lower anchor retaining bolt is obscured from view until the headliner is detached from the roof panel. Item 7 : Safety belt retractor | -
Remove the safety belt retractor. - Remove the bolt.
- Lift the retractor to detach the locating tangs.
| Installation Details Item 7 : Safety belt retractor CAUTION:Make sure the safety belt locating tangs are correctly located. |