Contour V6-153 2.5L DOHC (1996)
Fig. 2 Inboard CV Joint Removal Tools
7. Remove inner joint from intermediate shaft using tools shown, or their equivalents.
8. Remove driveshaft from vehicle.
9. Reverse procedure to install, noting the following:
a. New front axle retainer nut must be used.
b. New driveshaft bearing retainer circlips must be used.
c. New ball joint pinch nut and bolt must be used.
d. Check transaxle fluid, add if needed.
Intermediate
CAUTION: In all service operations the driveshaft bearing retainer circlips must be replaced with a new part. Do not begin this procedure unless a new
hub retainer nut, lower control arm to steering knuckle attaching bolt and nut, and the circlips are available. Once removed, these components must not
be reused during assembly/installation. Their torque holding ability or retention capability is diminished during removal.
1. Remove righthand driveshaft.
2. Remove intermediate driveshaft support bearing nuts and bearing shield.
3. Remove exhaust clamp and two bolts.
4. If necessary to achieve clearance, remove intermediate driveshaft support bearing bracket and three bolts.
5. Remove intermediate driveshaft from transaxle.
6. Remove and discard driveshaft bearing retainer circlip.
7. Reverse procedure to install, noting the following:
a. New front axle retainer nut must be used.
b. New driveshaft bearing retainer circlip must be used.
c. New ball joint pinch nut and bolt must be used.
d. Use care when installing intermediate driveshaft into transaxle not to damage seal.
e. Ensure proper engagement of intermediate driveshaft spline into transaxle side gears and that bearing retainer circlip is properly seated.