Removal and Installation Name Specification Back panel with reinforcement Removal | -
General notes - Necessary removal work: bumper, lock striker, rear lamps, trim panels, liftgate seal.
- Fold back the carpets and move the wiring back away from the working area.
| | -
Back panel with reinforcement (on both sides) - Preliminary separating cuts.
| | -
Back panel - Mill out the spot welds (Ø 8 mm, two panel layers).
- Mill out the spot welds (Ø 10 mm, two panel layers).
| Installation | -
General Instructions. - Drill holes (Ø 9 mm) in the new part in the area of the reinforcing plate for puddle welding
| | -
Back panel with reinforcement (on both sides) - Apply clinched flange protection.
| | -
Back panel with reinforcement | | |