Crown Victoria V8-4.6L CNG SOHC VIN 9 (1999)
NOTE: Wipe off the urethane glass prep WSB-M5B280-C or equivalent immediately after application because it flash dries. Two coats of the
Urethane Glass Prep must be applied.
4. Align the windshield glass to the body.
^
Place the windshield glass to the body.
^
Center the windshield glass in the opening.
^
Adjust the windshield stops.
^
Mark the windshield glass alignment on the glass and the body.
5. Remove the windshield glass from the vehicle and place it back onto the work table.
6. Thoroughly shake and stir the Urethane Glass Primer WSH-M2G314-B or equivalent to make sure of even pigment mixing.
7. Using a clean wool applicator, apply primer to interior glass edges 21 mm (0.8 inch) along the top and sides and 70 mm (2.75 inch) wide along
the bottom.
NOTE: Allow a minimum of five minutes for the glass primer to dry.
8. Install the instrument panel upper finish panel.
9. Apply the new Urethane Adhesive WSB-M2G316-B or equivalent in an even bead onto the existing urethane on the pinch weld.
NOTE:
^
Leave a door window slightly open until the adhesive is cured.
^
Apply the new urethane on top of the existing material on the pinch weld.
^
The newly-applied bead should be triangular in shape.
10. Install the windshield glass on the pinch weld, then align the windshield glass to the body using the alignment marks.
11. Install the cowl top vent panel.
12. Install the windshield pivot arms.
13. Install the headliner.
14. Install the visors.
15. Install the windshield garnish mouldings.
16. Install the interior rear view mirror.
17. Check the installation for air and water leaks through the urethane seal.
