Crown Victoria V8-4.6L Flex Fuel (2008)
Part 2
Removal
1. Remove the headliner.
2. Disconnect the 2 front and 2 rear drain hoses.
3. Disconnect the roof opening panel motor electrical connector.
4. Position the roof opening panel motor wiring harness aside.
-
Remove the tie strap.
-
Release the 5 wiring harness retaining clips.
5. CAUTION: Support the roof opening panel to prevent the unit from dropping.
Remove the 6 roof opening panel frame bolts.
6. Remove the 2 roof opening panel support strap bolts.
7. Remove the roof opening panel.
Installation
1. NOTE: Make sure the roof opening panel motor wiring harness is not pinched by the roof opening panel frame.
Position the roof opening panel to the vehicle.
2. Install the 6 roof opening panel frame bolts and tighten in the sequence shown.
-
Tighten to 10 Nm (89 lb-in).