Crown Victoria V8-4.6L Flex Fuel (2008)
5. NOTE: When installing the brake caliper anchor plate, new brake caliper anchor plate bolts must be used.
Remove the 2 brake caliper anchor plate bolts and the brake caliper anchor plate.
^
Discard the bolts.
^
To install, tighten new anchor plate bolts to 160 Nm (118 ft. lbs.).
6. To install, reverse the removal procedure.
7. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and
procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury.
If equipped with fire suppression system, repower the system.