Crown Victoria V8-4.6L Flex Fuel (2008)
Brake Caliper: Service and Repair
Brake Caliper Anchor Plate, Rear
Brake Caliper Anchor Plate
Removal and Installation
1. WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in Fire
Suppression System. Failure to follow the instructions may result in serious personal injury.
With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Disconnect the rear parking brake cable and conduit.
3. Remove the axle shaft.
4. WARNING: Use tools, not fingers, to hold flagnuts. Flagnuts may slip or spin unexpectedly when removing fasteners. Failure to follow
this instruction may result in injured fingers.
Remove the 4 retainers and the brake caliper anchor plate.
^
To install, tighten to 68 Nm (50 ft. lbs.).
5. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and
procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury.
If equipped with fire suppression system, repower the system.
6. To install, reverse the removal procedure.