Crown Victoria V8-4.6L SOHC VIN 6 (1996)
If the vehicle's striker compares to FIGURE 2, obtain Service Kit F6AZ-16K689-AA.
NOTE:
If you are unable to perform either of these repairs due to previous modification, call 1-800-325-5621 Be prepared to describe the condition in detail.
Repair Procedure # 1
1.
Open hood to the full open position.
2.
Apply suitable tape to the back of each rivet to prevent rivet waste from falling inside the hood assembly.
3.
Cover engine, fenders and grill with blanket to catch any rivet waste.
CAUTION
Use caution not to damage the underhood sheet metal.
4.
Using a suitable grinder, grind off the striker plate rivet heads.
5.
Using a suitable punch and hammer, knock out the remaining rivet material. Remove the striker plate, tape and rivet waste from the hood
assembly.
NOTE:
The new striker plate must be positioned with the rolled edge facing up and the hole pattern aligned with the holes in the hood. Also, the part number
stamped on the striker plate must be located toward the front of the vehicle. See Figure 3.
6.
Position the striker plate, and secure using all four (4) supplied rivets.
7.
Remove blanket. Verify proper latch function and hood alignment.
Repair Procedure # 2
1.
Open hood to the full open position.
2.
Apply suitable tape to the back of each rivet to prevent rivet waste from falling inside the hood assembly.
3.
Cover engine, fenders and grill with blanket to catch any rivet waste.
CAUTION
Apply tape to the drill bit to create a "drill stop" no more than one (1) inch from the tip to prevent damage to the outer hood panel.
4.
Using a 1/4 drill bit, drill out the striker plate rivet heads. It necessary, use a suitable punch and hammer to remove any remaining rivet material.
5.
Remove the striker plate and any rivet waste from the hood assembly.
