Crown Victoria V8-4.6L SOHC VIN 6 (1996)
Refer to the Service Procedure for details.
PART NUMBER
PART NAME
F6AZ-9L494-AA
High Temperature Nickel Anti-Seize
Lubricant
OTHER APPLICABLE ARTICLES: NONE
SUPERSEDES: 98-4-5
WARRANTY STATUS: INFORMATION ONLY
OASIS CODES: 301000, 702300, 703000, 703400
Service Procedure
1.
Verify concern.
2.
Pre-checks to include:
^
Check OASIS and TSBs for vehicle-specific brake/vibration concerns
^
Visually inspect suspension bushings/ball
joints
^
Visually inspect tire conditions and pressure
^
Check wheel bearing end-play
3.
Remove wheel/tire.
4.
Remove caliper.
5.
For vehicles with two-piece hub/rotor:
a.
Mark rotor and wheel stud for proper indexing during reassembly.
b.
Remove rotor.
NOTE:
THE ROTOR MUST HAVE SUFFICIENT THICKNESS AFTER MACHINING TO BE OVER THE MINIMUM THICKNESS SPECIFICATION C
6.
Measure rotor thickness and record measurement. Replace rotor if below the minimum thickness specification cast in the rotor.
CAUTION:
DO NOT USE ABRASIVE SANDING DISC SINCE IT WILL REMOVE METAL FROM MOUNTING SURFACES AND ADVERSELY AFFECT ROTOR LATERAL RUNOUT.
7.
Remove corrosion from wheel mounting surface, both rotor mounting surfaces, and hub mounting surface. A die grinder with a Scotchbrite(R) surfa
8.
For vehicles with two-piece hub/rotor, reinstall rotor onto hub, aligning with marks from Step 5a.
NOTE:
READ THE ENTIRE OPERATING MANUAL AND VIEW THE VIDEO SHIPPED WITH THE LATHE BEFORE INSTALLING, OPERATING, OR SERVICING THE LATHE.
9.
Machine rotors using the Rotunda Hub-Mount Brake Lathe / Pro-Cut (201-00002).
a.
Install hub adapter and silencer belt (where applicable).
b.
Install cutting lathe.
NOTE:
TOTAL INDICATED READING (TIR) TARGET IS 0.000 mm, MAXIMUM IS O.O6 mm (0.003").
c.
Adjust lathe oscillation using a dial indicator.
