Crown Victoria V8-4.6L SOHC VIN 6 (1996)
1.
Cut brake line in locations shown in Figure 5.
2.
Obtain necessary length of straight 6 mm brake line and appropriate double flare fittings.
NOTE:
Install fittings on brake line before flaring ends.
3.
Make a double flare to brake line ends as outlined in Section 06-06 of the 1996 Town Car/Crown Victoria/Grand Marquis Service Manual.
4.
Using removed brake line section as a guide, bend new brake line to match the contour of the frame rail.
5.
Install replacement brake line. Make sure there is an 8-12 mm clearance between the brake line and the floor pan and that there is no contact
between any of the lines.
6.
Install new front and intermediate clips as shown in Figure 3.
7.
Bleed brake system.
8.
Lower vehicle.
9.
Top-oft brake reservoir.
10.
Turn air suspension switch On, if equipped.
11.
Check vehicle for proper brake operation and brake fluid leaks.
