ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 9263 > < Initial Inspection and Diagnostic Overview|Page 9261
Page 3
background image

Marquis with an ohmmeter to chassis ground.

Is there continuity?

YES

SERVICE circuit 930 (P/LG) Town Car or 465 (W/LB) Crown Victoria and Grand Marquis for short to ground.

NO

REPLACE passenger side door handle switch.  RESTORE vehicle.  RETEST system.

B1322 - LF Door Ajar, Short To Ground

DTC B1322: Left Front Door Ajar, Short To Ground

B1322-1 - Check LH Front Door Closed

-

Verify that the door is fully closed to second latch.

-

Rerun on-demand self test.

Is DTC B1322 still present?

YES

GO to B1322-2.

NO

System operating normally.

B1322-2 - Check Circuit 867 (DB)

-

Disconnect Lighting Control Module Connector C2.

-

Ensure that door is closed.

-

Using an ohmmeter, connect to ground, measure resistance at lighting control module connector Pin C3-8.

Is resistance less than 10K ohms?

YES

GO to B1322-3.

NO

REPLACE lighting control module.  RETEST system.

B1322-3 - Check Driver Door Ajar Switch

-

Disconnect LH front driver door ajar warning switch.

-

Using an ohmmeter connected to ground, measure resistance at lighting control module Pin C2-11, Circuit 867 (DB).

Is resistance 5 ohms or less?

YES

SERVICE Circuit 867 (DB) for short to ground.  RETEST system.

NO

SERVICE door ajar switch for stuck switch.  RETEST system.

B1566 - Door Ajar, Short To Ground

DTC B1566: Door Ajar - Short To Ground

NOTE: Ford DOES NOT provide a procedure to perform the following pinpoint test without the Rotunda New Generation Star (NGS) tester
007-00500 or equivalent.

B1566-1 - Rerun Test

-

Make sure that all doors are closed to second latch.

-

Repeat on-demand self-test.

Is DTC B1566 still present?

YES

GO to B1566-3.

NO

GO to B1566-2.

B1566-2 - Make Sure That Switch Is Not Sticking

-

Set NGS tester to read P_DR_LC PID.

-

Open and close doors several times.  Test passenger front and both rear doors.

Does PID show that doors are open and closed as expected?

YES

System operating normally.

NO

REPLACE door open warning lamp switch in door that was sticking.  RESTORE vehicle.  RETEST system.

Initial Inspection and Diagnostic Overview|Page 9263 > < Initial Inspection and Diagnostic Overview|Page 9261