Crown Victoria V8-4.6L SOHC VIN 6 (1996)
Parts Replacement Chart
5. Install attachment parts in proper sequence shown in the applicable illustration. Tighten the replacement bolt to 34-46 Nm (25-33 lb-ft). Original
parts are to be replaced with service parts indicated in Parts Replacement Chart.
6. When servicing a multiple belt and attachment, install nut to the bolt in the tunnel area from the underside of the rear floor pan. Tighten to 34-46
Nm (25-33 lb-ft).
Seat Belt Without Anchor Plate Thread Damage
The seat and shoulder safety belts are factory-installed in their proper locations. If the belts are removed for any reason, they should be installed using
proper service procedures. The 7/16-inch x 20 TORX(R) head anchor bolts must be hand-started and then tightened to 34-46 Nm (25-33 lb-ft).
1. Remove damaged bolt from anchor reinforcement and discard.
2. Install a new bolt by hand. Tighten to 34-46 Nm (25-33 lb-ft).
Shoulder Strap Adjuster With Stripped Weld Nuts, Front Seat