Crown Victoria V8-4.6L SOHC VIN 6 (1996)
4.
Loosen the two (2) upper power window regulator retaining nuts. DO NOT REMOVE THE BOTTOM RIVETS (Figure 2).
5.
Loosen the two (2) screws retaining the front door glass run to door inner sheet metal.
6.
Pull the glass up and down in the glass run channels, then align the door window glass with the front door window channel bracket.
NOTE:
FOR PROPER WINDOW GLASS ALIGNMENT, BE SURE TO INSTALL THE WINDOW GLASS AT THE REGULATOR
ASSEMBLY-TO-GLASS FORWARD RIVET FIRST.
7.
Install the door window glass to the regulator assembly at the forward rivet (closest to A-pillar) location, then the rear rivet location (use 1/4"x0.94
rivet 385323-S100). Refer to the 1996 Crown Victoria/Grand Marquis Service Manual, Page 01-11-30 for front door window glass installation.
8.
Cycle the glass completely to the top and then to the bottom.
9.
Torque the upper two (2) regulator retaining nuts to 9-14 N.m (80-124 lb-in). Torque the two (2) door glass run screws to 9-12 N.m (80-106
lb-in).
10.
Cycle the door glass to verify repair.
11.
Reinstall belt line weatherstrip, outside mirror, watershield and trim panel.
12.
Retest the repair.
PART NUMBER
PART NAME
385323-S100
Rivet - 1/4"x0.94 (2 Per Vehicle)
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage
OPERATION
DESCRIPTION
TIME
961004A
Adjust Right Front Door
0.8 Hr.
Glass Mechanism And
Glass Run
DEALER CODING
CONDITION
BASIC PART NO.
CODE
7423200
41
OASIS CODES: 102000