Crown Victoria V8-4.6L SOHC VIN 6 (1996)
NOTE
THE OUTPUT SHAFT AND ARM ARE KEYED FOR PROPER ORIENTATION.
6.
Reinstall the output arm bolt and torque to 132-180 Lb-in. (15-20 N.m).
7.
Reinstall the plastic output arm dust cover.
8.
Rotate the output arm slowly clockwise one full turn by hand, then turn the output arm by hand counter-clockwise to seat the detent in the output
arm against the stop on the plastic windlatch slide.
9.
Position the vehicle wiper arm linkage so that the wiper blades are at the bottom of the windshield, just above the parked position.
10.
Install the wiper motor in the vehicle and connect the wiper arm linkage per the procedures outlined in Section 01-16 or Section 501-16 Wiper and
Washer Systems - Removal and Installation, of the appropriate model year Workshop Manual.
TROUBLESHOOTING:
Parts Block
OTHER APPLICABLE ARTICLES: NONE
SUPERSEDES: 02-10-7
WARRANTY STATUS: INFORMATION ONLY
OASIS CODES: 202000, 290000
Disclaimer
