Crown Victoria V8-4.6L SOHC VIN W (2005)
2. Remove the two bolts and the brackets.
3. Remove the two harness retainers from the frame.
16. Remove the steering gear nuts.
17. Remove the studs and position the steering gear aside.
-
Support the steering gear away from the crossmember.
18. Release the brake line from the retaining clips at the rear of the crossmember.
19. Lower the vehicle.
20. Using the special tool, raise the engine to remove the engine weight from the crossmember.
21. Raise and support the vehicle.
22. Remove the six LH and RH control lower arm rear mounting bolts.
23. Position a suitable support table under the crossmember.
