Crown Victoria V8-4.6L SOHC VIN W (2005)
Impact Sensor: Service and Repair
Side Impact Sensor
SIDE IMPACT SENSOR
Removal
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
To reduce the risk of personal injury, do not use any memory saver devices.
-
Vehicle sensor orientation is critical for correct system operation. If a vehicle equipped with an air bag supplemental restraint system
(SRS) is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Replace and correctly position
the sensor or any other damaged supplemental restraint system (SRS) components whether or not the air bag is deployed.
NOTE:
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
-
The LH side is shown, the RH side is similar.
-
For this procedure, the side impact sensors are located at the base of each B-pillar.
1. Depower the system.
2. Remove the driver side front door scuff plate.
3. Remove the driver side rear door scuff plate.