Crown Victoria V8-4.6L SOHC VIN W (2005)
Ride Height Sensor: Service and Repair
Suspension Height Sensor-Air
Suspension Height Sensor-Air
Removal and Installation
WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle.
This can be accomplished by turning off the air suspension switch located in the LH rear quarter trim panel. Failure to do so can result in
unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations.
1. Turn the air suspension switch to the OFF position.
2. Raise and support the vehicle. Refer to Maintenance/Service and Repair.
3. Disconnect the air suspension height sensor electrical connector.
4. Disconnect the connecting link.
5. Remove the bolts and the height sensor.
6. To install, reverse the removal procedure.
