Crown Victoria V8-4.6L SOHC VIN W (2005)
5. Remove the LH lateral arm-to frame nut and bolt.
^
Discard the nut.
6. Detach the parking brake cable from the retainer bracket.
7. Remove and discard the nuts.
8. NOTE: The Watts link pivot stud is coated with a dry adhesive. A new pivot stud must be installed whenever the pivot nut or stud is loosened or
removed. Use a new Watts link pivot nut and stud service kit.
NOTE: If the Watts link pivot stud on the axle assembly loosens while removing the pivot nut, continue to loosen the pivot stud until you can
insert an open end wrench to hold the pivot stud. While holding the pivot stud, remove the pivot nut.
Remove and discard the nut.
