E 150 V8-4.6L (2007)
All engine support insulators
1. CAUTION: Clean the engine support insulator-to-cylinder block mating surface of any dirt or foreign material prior to installation.
Position the engine support insulator being serviced and install the engine support insulator-to-cylinder block bolts, or bolts and nut.
^
Tighten to 80 Nm (59 ft. lbs).
RH engine support insulator
2. Position the RH engine support insulator-to-crossmember bracket and install the 2 nuts.
^
Tighten to 90 Nm (66 ft. lbs).
3. Install the engine support insulator-to-crossmember bracket nut.
^
Tighten to 90 Nm (66 ft. lbs).
4. Using a suitable jack positioned on the RH rear of the cylinder block, lower the engine.
LH engine support insulator
5. Position the LH engine support insulator-to-crossmember bracket and install the 3 nuts.
^
Tighten to 90 Nm (66 ft. lbs).