E 150 V8-4.6L (2007)
6. Using a suitable jack positioned on the LH rear of the cylinder block, lower the engine.
All engine support insulators
7. Install the 4 exhaust Y-pipe flange nuts.
^
Tighten to 40 Nm (30 ft. lbs).
8. Install the 4 engine support insulator-to-crossmember bracket nuts.
^
Tighten to 90 Nm (66 ft. lbs).
9. If servicing the RH engine support insulator, install the starter motor. For additional information, refer to Starting System.
10. Position the cooling fan shroud and install the 2 bolts.
^
Tighten to 6 Nm (53 inch lbs).