E 150 V8-4.6L (2007)
23. Disconnect the evaporator inlet fitting.
1
Remove the evaporator inlet fitting bracket screw.
2
Disconnect the evaporator inlet fitting.
-
Discard the O-ring seal.
-
To install, tighten the fitting to 18 Nm (13 lb-ft).
-
To install, tighten the screw to 2 Nm (18 lb-in).
24. Remove the screws and the evaporator housing support bracket.
25. Remove the evaporator core cover.
1
Remove the 5 screws.
2
Remove the 4 screws.
3
Remove the evaporator core cover.
26. Remove the evaporator core.
27. To install, reverse the removal procedure.
-
Install a new gasket seal and new O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
28. Evacuate, leak test and charge the refrigerant system.