E 150 V8-4.6L (2007)
1. Inspect and clean both spring lock coupling ends. Install new O-ring seals and garter springs if necessary.
-
Lubricate the O-ring seals with clean engine oil.
2. CAUTION: Make sure the fuel tube clicks into place when installing the tube. To make sure that the fuel tube is fully seated, pull on the
tube.
Fit the male fitting into the female end and push until the garter spring snaps over the flared end of the female end.
3. To make sure the spring lock coupling is fully engaged, pull on the lines, then install the fuel tube safety clip.
Disconnect - Type II
WARNING:
-
Do not smoke or carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly
flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in personal injury.
-
Do not carry personal electronic devices such as a cell phones, pagers or audio equipment of any type when working on or near any
fuel-related components. Highly flammable mixtures are always present and can be ignited. Failure to follow these instructions may
result in personal injury.
-
This procedure involves fuel handling. Be prepared for fuel spillage at all times and always observe fuel handling precautions. Failure to
follow these instructions may result in personal injury.
-
Fuel in the fuel system remains under high pressure even when the engine is not running. Before repairing or disconnecting any of the
fuel lines or fuel system components, the fuel system pressure must be relieved to prevent accidental spraying of fuel, causing personal
injury or a fire hazard. Failure to follow these instructions may result in personal injury.
CAUTION:
-
If the liquid or vapor tube is damaged (torn, holes or delaminated), a new tube assembly must be installed. Do not use aftermarket
sleeving. Do not re-adhere loose sleeving material.
