E 150 V8-4.6L (2007)
-
When reusing liquid or vapor tube connectors, make sure to use compressed air to remove any foreign material from the connector retaining clip
area before separating from the tube. Apply clean engine oil to the end of the tube before inserting the tube into the connector.
-
Fuel injection equipment is manufactured to very precise tolerances and fine clearances. It is, therefore, essential that absolute cleanliness is
observed when working with these components. Always install blanking plugs to any open orifices or tubes.
1. Release the fuel pressure.
2. Disconnect the battery ground cable.
3. Disconnect the safety clip from the male hose.
4. Install the special tool and push into the spring lock coupling.
5. Separate the spring lock coupling.
Connect - Type II
1. Inspect the spring lock coupling and the tube for damage. Remove any dirt or obstructions.