E 150 V8-4.6L SOHC VIN W (2004)
Air Bag Control Module: Technician Safety Information
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
The restraints control module (RCM) orientation is critical for correct air bag supplemental restraint system (SRS) operation. If a vehicle
equipped with an SRS system has been involved in a collision inspect the RCM mounting area and bracket for deformation. If damaged,
the RCM must be replaced whether or not the air bags have deployed. In addition, make sure the mounting area of the RCM is restored
to its original condition.
-
Vehicle sensor orientation is critical for proper system operation. If a vehicle equipped with an air bag supplemental restraint system
(SRS) is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Replace and properly position the
sensor or any other damaged SRS components whether or not the air bag is deployed.
-
The restraint system diagnostic tool is for restraint system service only. Remove from vehicle prior to road use. Failure to remove could
result in injury and possible violation of vehicle safety standards.
-
To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing
any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing, adjusting or striking
components near the front or side air bag sensors, such as doors, instrument panel, console, door latches, strikers, seats and hood latches.
The front impact severity sensor is located behind the grille.
To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect
auxiliary batteries and power supplies (if equipped).
-
To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the supplemental restraint
system (SRS) deactivation/reactivation procedure.
-
The tightening torque of the air bag restraints control module (RCM) bracket retaining nuts is critical for correct system operation.
