E 250 V8-4.6L VIN W (2006)
9. Disconnect the door latch cable and the door lock cylinder actuating rod.
All Doors
10. Remove the door latch remote control screw.
11. Remove the 3 door latch screws.
-
To install, tighten to 12 Nm (9 lb-ft).
12. Remove the door latch assembly.
-
If equipped, disconnect the door lock actuator electrical connector.
13. To install, reverse the removal procedure.
Double Door Latch
DOOR LATCH - SIDE AND REAR, DOUBLE LATCH
Removal and Installation
All Latches
1. If equipped, remove the door trim panel.
2. If equipped, position the watershield aside.