E 350 V8-6.0L DSL Turbo (2007)
13. Prior to removing the injector assembly, insert clean shop towels in the oil drain holes adjacent to each glow plug.
14. CAUTION: To prevent engine damage, do not use air tools to remove the fuel injectors. The snap ring that extracts the injector can
dislodge and fall into the oil drain hole.
CAUTION: Failure to account for all snap rings or pieces prior to placing the vehicle back in service can cause engine damage. A missing
snap ring can be ingested into the lube oil system, causing serve engine damage.
NOTE: There is no need to drain the fuel rail.
Remove the bolt, the fuel injector hold down and the fuel injector.
15. NOTE: Make sure the notch in the base is aligned in the hold-down clamp.
Insert the injector hold-down clamp into the special tool base.
16. CAUTION: While centering the base between the 2 bridges, snug the hold-down bolt only. Do not tighten it or engine damage can occur.
Install the assembly in between the bridges as if you are installing an injector.
