E 350 V8-6.0L DSL Turbo (2007)
24. Install the transmission fluid indicator and tube nut.
^
Tighten to 8 Nm (71 inch lbs).
25. Connect the generator B+ wire and electrical connector, position back the boot and connect the wiring pushpin.
^
Tighten to 8 Nm (71 inch lbs).
26. NOTE: If there is any oil residue, clean both connecting ports and the inside surface of the charge-air-cooler (CAC) tube to prevent the tube from
blowing off.
Position the CAC tube, oil fill tube and bracket and install the nuts.
27. Connect the oil fill tube at the valve cover.
