E 350 1 Ton Van V10-6.8L VIN S (1997)
8. Install the (A) bottom forward clutch pressure plate with beveled face downward, the (B) forward clutch pressure spring, the (C) clutch pack
(number of plates are model-dependent), and the (D) top forward clutch pressure plate.
9. Install the selective forward clutch pressure plate retaining ring.
10. Using a feeler gauge, check the stack-up clearance in three places, 120 degrees apart.
-
If the clearance is not to specification, install the correct selective forward clutch pressure plate retaining ring and recheck the clearance.
11. Install the No. 8B forward clutch needle bearing.
NOTE:
-
Lightly lubricate the needle bearing with petroleum jelly to hold it in place during assembly.
-
The bearing large inner diameter radius must face inward.
