E 450 V10-6.8L (2008)
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Remove the seat.
2. Remove the seat cushion.
3. Remove the cushion trim cover.
1. Release all cushion trim cover J-clips.
2. Remove the cushion frame from the cushion foam pad and cushion trim cover.
3. Separate the hook-and-loop strips and remove the cushion trim cover.
4. To install, reverse the removal procedure.
Seat Backrest Cover - Rear, Bucket
SEAT BACKREST COVER - REAR, BUCKET
Removal and Installation
1. Remove the RH and LH armrests from the seat.
2. Release the J-clip at the lower edge of the backrest trim cover.
3. CAUTION: Use care when separating the seat backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn
from the seat backrest foam pad.
Invert the backrest trim cover, release the hook-and-loop strips and remove.
4. To install, reverse the removal procedure.
Seat Cushion Cover - Rear, Bucket
SEAT CUSHION COVER - REAR, BUCKET
Removal and Installation
1. Remove the seat cushion.
2. Release the cushion trim cover J-clips.