E 450 V10-6.8L (2008)
^
Stage 1: Tighten to 2 Nm (18 lb-in).
^
Stage 2: Tighten to 20 Nm (15 lb-ft).
^
Stage 3: Tighten an additional 60 degrees.
4. NOTE: Lubricate the crankshaft rear seal with engine oil before installation.
Using the special tools, install the crankshaft rear seal.
5. NOTE: Lubricate the crankshaft oil slinger with clean engine oil before installation.
Using the special tools, install the crankshaft oil slinger.
6. Install the engine rear cover plate.
7. Install the flexplate.
8. Using the special tool, raise the engine.
9. Install the oil pan.