E 450 V8-5.4L (2009)
5.4L (2V) engine
7. Tighten the bolts in 3 stages in the sequence shown.
-
Stage 1: Tighten to 2 Nm (18 lb-in).
-
Stage 2: Tighten to 20 Nm (177 lb-in).
-
Stage 3: Tighten an additional 60 degrees.
All engines
8. Install a new oil filter.
9. Lower the engine and remove the Engine Support Bar, Engine Lifting Bracket and the Modular Engine Lift Bar Adapter.
10. NOTE: RH shown, LH similar.
Install the 4 engine support insulator-to-crossmember nuts.
-
Tighten to 90 Nm (66 lb-ft).
11. Position the flexplate inspection cover and install the 2 bolts.
-
Tighten to 34 Nm (25 lb-ft).