E 450 V8-5.4L (2009)
-
Stage 4: Tighten an additional 90 degrees without exceeding 200 Nm (148 lb-ft).
5.4L (2V) engine
13. Using a new crankshaft pulley bolt, install the crankshaft pulley bolt and washer. Using the Strap Wrench to hold the crankshaft pulley, tighten the
bolt in 4 stages:
-
Stage 1: Tighten to 90 Nm (66 lb-ft).
-
Stage 2: Loosen one full turn.
-
Stage 3: Tighten to 50 Nm (37 lb-ft).
-
Stage 4: Tighten an additional 90 degrees.
All engines
14. NOTE: Lubricate the O-ring seal with clean engine oil prior to installation.
Install the CMP sensor and the bolt.
-
Tighten to 10 Nm (89 lb-in).
15. Connect the CMP sensor electrical connector.
16. Position the transmission cooler tube support bracket and the starter wiring harness support bracket and install the nut.
-
For 4.6L engines, tighten to 10 Nm (89 lb-in).
-
For 5.4L engines, tighten to 28 Nm (21 lb-ft).
17. Position the power steering pump and install the 3 bolts.
-
Tighten to 25 Nm (18 lb-ft).