ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 6759 > < Initial Inspection and Diagnostic Overview|Page 6757
Page 12
background image

-

Use the recorded results from the SJB self-test.

-

Is DTC B2A35 present?

Yes

GO to D2.

No

GO to D4.

-------------------------------------------------
D2 CHECK THE SJB INTERIOR COURTESY LAMP OUTPUT CIRCUIT FOR A SHORT TO VOLTAGE

 

-

Disconnect: SJB C2280a.

-

Ignition ON.

-

Observe the interior courtesy lamps.

-

Do the interior courtesy lamps continue to illuminate?

Yes

For cutaway vehicles, GO to D3.

For all other vehicle types, REPAIR circuit VLN33 (GY/VT) for a short to voltage. CLEAR the DTCs. REPEAT the self-test.

No

GO to D9.

-------------------------------------------------
D3 ISOLATE THE SHORT TO VOLTAGE

 

-

Ignition OFF.

-

Disconnect: Body Builder C3359.

-

Ignition ON.

-

Observe the front interior courtesy lamp.

-

Does the front interior courtesy lamp continue to illuminate?

Yes

REPAIR circuit VLN33 (GY/VT) for a short to voltage. CLEAR the DTCs. REPEAT the self-test.

No

The vehicle is operating correctly. REFER to the body builder information to continue diagnosis.

-------------------------------------------------
D4 CHECK THE SJB INSTRUMENT PANEL DIMMER SWITCH DOME LAMP REQUEST PID

 

-

Ignition ON.

-

Enter the following diagnostic mode on the scan tool: SJB DataLogger.

-

Monitor the SJB instrument panel dimmer switch dome lamp request PID (DOMELM_SW).

-

Does the PID indicate the instrument panel dimmer switch is in the DOME LAMP position?

Yes

GO to D5.

No

Initial Inspection and Diagnostic Overview|Page 6759 > < Initial Inspection and Diagnostic Overview|Page 6757