E 450 V8-5.4L (2009)
All semi-floating axles
5. Using the C-Frame and Screw Installer/Remover, remove and discard the wheel stud.
Installation
NOTICE: Do not use air tools to install wheel studs or damage to the serrations can occur.
All semi-floating axles
1. Position the new wheel stud in the flange, making sure that the serrations are aligned with those made by the original wheel stud.
2. NOTE: Do not use a wheel nut that was previously removed from the vehicle.
NOTE: Make sure to use washers that have an ID that is larger than the OD of the wheel stud serrations. Use enough washers (approximately 4) to
allow the wheel stud to fully seat against the hub flange.
Install washers and a wheel nut on the wheel stud and tighten the wheel nut until the wheel stud seats against the flange.
Dana 60 semi-floating axles
3. Install the parking brake shoe adjusting screw.
4. Install the parking brake shoe adjusting screw spring.
All semi-floating axles
5. Install the brake disc.
6. Install the disc brake caliper anchor plate.
