E 450 V8-5.4L (2009)
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CLEAR the DTCs. REPEAT the
network test with the scan tool.
-------------------------------------------------
Pinpoint Test J: Intermittent No Medium Speed Controller Area Network (MS-CAN)
Communication, Communication Can Be Intermittent
Communications Network
Pinpoint Tests
Pinpoint Test J: Intermittent No Medium Speed Controller Area Network (MS-CAN) Communication, Communication Can Be Intermittently
Established
Normal Operation
The Medium Speed Controller Area Network (MS-CAN) uses an unshielded twisted pair cable, circuits VDB06 (GY/OG) and VDB07 (VT/OG). In the
event that one of the 2 network circuits (MS-CAN + or MS-CAN -) becomes open to a module on the network, unreliable network communication to all
modules on the network may result.
This pinpoint test is intended to diagnose the following:
-
Wiring, terminals or connectors
PINPOINT TEST J: INTERMITTENT NO MS-CAN COMMUNICATION, COMMUNICATION CAN BE INTERMITTENTLY
ESTABLISHED
NOTE: Various modules will set network DTCs during this test procedure. Clear DTCs from all modules after the diagnostic procedure is completed.
NOTE: Failure to disconnect the battery when instructed will result in false resistance readings. Refer to Battery.
-------------------------------------------------
J1 CHECK THE DLC PINS FOR DAMAGE
-
Ignition OFF.
-
Disconnect the scan tool cable from the Data Link Connector (DLC).
-
Inspect DLC pins 3 and 11 for damage.
-
Are DLC pins 3 and 11 OK?
Yes
GO to J2.
No
REPAIR the DLC as necessary. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
J2 CHECK THE MS-CAN TERMINATION RESISTANCE