ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2447 > < Initial Inspection and Diagnostic Overview|Page 2445
Page 44
background image

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT all modules. CONNECT the negative battery cable. GO to K24.

No

For stripped chassis, GO to K22.

Otherwise, GO to K20.

-------------------------------------------------
K20 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND
WITH THE RCM DISCONNECTED

 

-

Disconnect: RCM C310b.

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT all modules. CONNECT the negative battery cable. GO to K25.

No

If the vehicle is equipped with a Trailer Brake Control (TBC) module, GO to K21.

If the vehicle is not equipped with a TBC module, GO to K22.

-------------------------------------------------
K21 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND
WITH THE TBC MODULE DISCONNECTED

 

-

Disconnect: TBC Module C2142.

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

Initial Inspection and Diagnostic Overview|Page 2447 > < Initial Inspection and Diagnostic Overview|Page 2445