E 450 V8-5.4L (2009)
6. NOTE: The manual control lever must be in the NEUTRAL position.
Using the TR Sensor Alignment Gauge, align the TR sensor slots. The TR Sensor Alignment Gauge is designed to fit snug.
7. NOTICE: Tightening one bolt before tightening the other may cause the Transmission Range (TR) sensor to bind or become damaged.
Using the TR Sensor Alignment Gauge, align the TR sensor and tighten the bolts in an alternating sequence.
-
Tighten to 9 Nm (80 lb-in).
8. Install the manual control lever.
1. Position the manual control lever.
2. Install a new manual control lever shaft outer nut.
-
Tighten to 33 Nm (24 lb-ft).
9. Install the TR sensor electrical connector.
10. With the manual control lever in NEUTRAL, connect the selector lever cable.
