Econoline E150 1/2 Ton V8-5.4L CNG VIN M (1998)
INSTALLATION
CAUTION: Use care not to get dirt in the rear axle housing.
1. Clean and inspect the rear anti-lock brake sensor.
1
Clean the axle mounting surface.
2
Inspect and clean the rear anti-lock brake sensor.
3
Inspect the rear anti-lock brake sensor O-ring for damage. Replace if necessary.
4
Lightly lubricate the rear anti-lock brake sensor O-ring with Synthetic SAE 75W 140 Rear Axle Lubricant F1TZ-19580-A or equivalent
meeting Ford specification WSL-M2C192-A.
2. Install the rear anti-lock brake sensor.
1
Position the rear anti-lock brake sensor and install the bolt.
2
Connect the electrical connector.
CAUTION: Do not apply force to the plastic rear anti-lock brake sensor connector.