Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
2. Place the (A) front case bushing with the (B) Rear Case Bushing Replacer and the (C) 127 mm (5 inch) Threaded Drawbar through the case and
into the rear case bushing.
3. Place the other portion of the (A) Rear Case Bushing Replacer over the (B) 127 mm (5 inch) Threaded Drawbar. Then, install the (C) washer and
the (D) nut hand-tight.
CAUTION: Make sure the bushing and tool are centered in the bore.
4. Hold the (A) Drawbar with a 1/2 inch wrench while turning the (B) nut with a 1-1/8 inch wrench until the front case bushing is fully seated.
Remove the tools.
