Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
Case: Service and Repair
Rear Case Bushings
Special Tools
DISASSEMBLY
NOTE: Inspect the case bushing bores for nicks or burrs. Remove any minor nicks or buff s using a fine oil stone. Remove the case bushings only if
they show signs of excessive wear or scoring.
1. Using the (A) Seal Remover and the (B) Impact Slide Hammer, remove the rear case bushing.
CAUTION: Be careful not to damage the case bore while removing the bushing.
NOTE: Always replace both bushings when either bushing is replaced. However, remove and replace only one bushing at a time. Use the other
bushing in the case to help align the tool and replacement bushing during installation.
ASSEMBLY