Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
8. Install the selective direct clutch pressure plate retaining ring.
9. Check the stack-up clearance.
1. Using a feeler gauge, check the stack-up clearance in three places, 120 degrees apart.
2. If the clearance is not to specification, install the correct selective direct clutch pressure plate retaining ring and recheck the clearance.
10. Install the No. 7 intermediate one-way clutch large thrust washer, aligning the (A) tabs with the (B) notches.
11. Install the bottom end cap.
NOTE: The top and bottom end caps are identical.
