Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
-
Remove the Pump Banding Tool.
-
Make sure the outer edges of the control body and the pump body are completely aligned.
5. Install the 2 coast clutch Teflon seals. Make sure the seals are fully seated in the stator support seal grooves and the (D) seal ends are oriented 180
degrees apart.
CAUTION: Make sure the (A) seal grooves in the stator support are clean and free of burrs.
CAUTION: Make sure the (B) seal ends are properly positioned together and not (C) separated.
6. Install the pump outer diameter square-cut front pump seal.
7. Install the front pump stator support seal.
