Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
(E) retainer, making sure it is properly seated.
2. Install the (B) converter clutch shift valve assembly. Then, apply pressure to the (F) end plug and install the (G) retainer, making sure it is
properly seated.
3. Install the (C) converter regulator valve assembly. Then, apply pressure to the (H) end plug and install the (J) retainer, making sure it is
properly seated.
2. Install the (A) gerotor gear set, with the (B) dot facing the control body assembly.
NOTE: Prior to installation, lightly lubricate the gerotor gears with clean MERCON(R) V Automatic Transmission Fluid XT-5-QM or
MERCON(R) V equivalent.
3. Lower the (A) control body and stator assembly onto the (B) pump body, aligning the (C) 28 mm hole in each body.
CAUTION: Prior to pump assembly, make sure all cup plugs are installed.
CAUTION: Inspect mating surfaces of the pump body and the control body to make sure they are clean and free of nicks and burrs.
4. Assemble the pump.
1. Loosely install the 11(A) M8x50 bolts and the (B) 10 mm alignment bolt.
2. Install the Pump Banding Tool, with the (C) clamp positioned by the (D) filter inlet.
3. Align the (E) outer bolt holes and tighten the (F) Pump Banding Tool.
4. Tighten the 11(A) pump bolts and remove the (B) 10 mm alignment bolt.
