Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
11. Using the (A) Puller, remove the (B) manual control lever seal,.
INSTALLATION
1. Using the (A) Shift Lever Seal Replacer, install the (B) manual control lever seal.
NOTE: Prior to installing the manual control lever seal, clean the bore opening with mineral spirits.
2. Install the manual control lever shaft assembly.
1. Install the manual control lever shaft assembly.
2. Install and seat the manual lever shaft retaining pin below the case surface.
3. Install the (A)parking pawl actuating rod and the (B) inner manual valve detent lever.
NOTE: The inner manual valve detent lever must be seated on the flats of the manual control lever shaft assembly, and the parking pawl
actuating rod must be through the guide plate.
NOTE: The manual control valve detent lever spring must be on the inner manual valve detent lever, and the detent lever pin must align with
the manual shift valve.
4. Install the inner manual valve detent lever nut.
NOTE: Use a crescent wrench on the manual control lever or the outer flats of the manual control lever shaft assembly when installing the
inner manual valve detent lever nut.
